Spudtech Forum
http://forum.spudtech.com/

Safety modification to push button sprinkler valve modificat
http://forum.spudtech.com/viewtopic.php?f=10&t=2300
Page 1 of 1

Author:  Pat-in-Omaha [ Sat Jun 15, 2013 9:42 am ]
Post subject:  Safety modification to push button sprinkler valve modificat

I built a tennis ball launcher using the Spudtech sprinkler valve that is modified with the pushbutton actuator.
One day I was testing it and it was sitting on the sidewalk fully loaded and charged to 60 psi. I accidentally kicked the button and sent the tennis ball into a steel trash can. Luckily it wasn't pointed at the cars that were sitting in the nearby parking lot. I cut off a plastic pop bottle screw off top and attached it around the button with some epoxy, being careful to not get any epoxy on the button. Now the button cannot be accidentally activated by a blunt object, like my foot. The lid can also be screwed on for more security.

Attachment:
Image 50.jpg
Image 50.jpg [ 161.35 KiB | Viewed 10166 times ]


Attachment:
Image 51.jpg
Image 51.jpg [ 152.99 KiB | Viewed 10166 times ]

Author:  twhiston [ Thu May 08, 2014 10:19 am ]
Post subject:  Re: Safety modification to push button sprinkler valve modif

I like your modification to the push button !!!

I use the pushbutton but I have it on the end of a hose instead of the top of the valve.

I am going to order a valve with the button on top and I will add your safety cover.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/