Spudtech Forum
http://forum.spudtech.com/

Questions about the Supah Valve
http://forum.spudtech.com/viewtopic.php?f=38&t=2161
Page 1 of 1

Author:  Spudtech [ Fri Jul 25, 2003 9:00 pm ]
Post subject:  Questions about the Supah Valve

Originaly posted by Bartman007,
I have become hooked on pneumatics and am thinking about buying a Supah Valve. I got a few questions... First off, has anyone measured the Cv of the Supah Valve and/or the Supah Valve Plus. Secondly, if I was to order one. Do you think I would get better performance by asking Joel to thread the exhaust hole 3/8" NPT (if he would do it) and using a 3/8" quick-exhaust, or by using a Supah Valve Plus
I would assume that the Supah Valve Plus would do a better job, but it is worth asking.
If the Supah Valve Plus is better, I think I might just buy a Supah Valve with the exhaust ported to 1" (again, if Joel will do it,) and supply my own sprinkler valve.

Peace,
-Bartman007

Author:  Spudtech [ Fri Jul 25, 2003 11:00 pm ]
Post subject:  Cv

Originaly posted by mta,
The 3/8" quick exhaust at mcmaster.com has a Cv of only 2.86. A 1" sprinkler valve does better than that. A 3/4" quick exhaust, on the other hand, has a Cv of 7.84, which probably beats a sprinkler valve.

As for the Cv of a Supah valve.. My 2" coaxial floating diaphragm valves have a Cv of 43, according to GGDT. The 2" Supah should be somewhat higher than that. Projecting the 2" performance to a 3" valve results in a Cv of 95+

One day somebody with a supah and a chronograph will post some real data on the valve so we can stop guessing.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/