Spudtech Forum

Originaly posted by FoxxLord,
I also ran into this problem with my 5' sleeved barrel but the idea can be used in any barrel size. It's pretty basic but it works.
http://www.geocities.com/cain333_2000/bore.gif

-Foxx

Originaly posted by robbie,
Do u have like a homepage with links to all your pages? Because you have a lot of kool sites but its hard to find them all

Originaly posted by FoxxLord,
That's not a bad idea. Maybe I'll compile them all today, it'll give me somethin to do. Check back later.

-Foxx

Originaly posted by FoxxLord,
http://www.geocities.com/cain333_2000

It's nothing special trust me, just a list for all my pages and pics.

-Foxx

Originaly posted by robbie,
nt

Originaly posted by Rocketbiker,
lol, seriously though, I was thinking of using some sort of spring on a ball valve. I had thought of the way you did it on your atom project and also debated on the rotary type of spring.
Oh yea thanks for the idea on the bore cleaner, I can't believe I didn't think of that first....D@mm!t.
later

Originaly posted by Rocketbiker,
...on your pop can barrel. If it's still intact. You may just have a few high spots that a little sanding will cure.