Spudtech Forum

acrylic vs polycarbonate
Page 1 of 1

Author:  Spudtech [ Wed Jul 16, 2003 7:00 pm ]
Post subject:  acrylic vs polycarbonate

Originaly posted by False,
I got hold of some 1/2" plastic sheets that I thought was polycarbonate(lexan)...sadly I found out when I put my powersaw to it that it was acrylic(plexi)Its a part of the endcap and at one point its only 4mm thick...
So...do you think I should continue to build my gun...and use some kind of remote ignition to try it out??

Author:  Spudtech [ Wed Jul 16, 2003 9:00 pm ]
Post subject:  better safe than sorry

Originaly posted by robertjuric,
id look to find something thicker, but im no expert, that might do.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group