|Page 1 of 1|
|Author:||Spudtech [ Thu Jul 24, 2003 4:00 pm ]|
|Post subject:||starting fluid|
Originaly posted by Bry12,i just bought some starting fluid with high ether content how much should i use and will it blow up my gun.
|Author:||Spudtech [ Thu Jul 24, 2003 6:00 pm ]|
|Post subject:||starting fluid works great..|
Originaly posted by _latke,
Spray a VERY small amount when using aerosols like starting fluid or right guard. Otherwise it will not ignite because the fuel mix (with the air inside the sealed chamber) is too rich. A good place to start is 1/4 second or less spray and go up from there to find the upper combustible limit. Also, SHAKE THE CAN first then clear the nozzle with a test spray to produce a fine mist. Then spray short burst into center of chamber so the mist mixes with the air.
Starting fluid works great and doesn't seem to harm PVC. You shouldn't "blow up" as long as you use pressure rated PVC and do a quality PVC PRIMER and cement job on the joints. BTW, use PVC primer. Oh, and...use PVC primer. Primer is usually purple but available in clear also. Use primer. : )
|Author:||Spudtech [ Thu Nov 18, 2004 12:00 am ]|
Originaly posted by spin69,I use a quick squirt of Johnsens premium starting fluid. It contains ether, heptane, butane, and propane. It really works great!!!!!!!
|Page 1 of 1||All times are UTC - 6 hours|
|Powered by phpBB® Forum Software © phpBB Group|