Search    Main Website    Parts Store    Forum    FAQ    Login

Board index » General » Combustion Cannons




Post new topic Reply to topic  [ 4 posts ] 
Author Message
 Post Posted: Wed Oct 24, 2012 9:32 pm 
Offline

Joined: Wed Oct 24, 2012 8:55 pm
Posts: 6
So I've been toying with this idea for a long time. I want to build an AT4-styled launcher. 3" PVC would make up the exterior body, a reducer would attach a 1.5" barrel running INSIDE the body to about 2" from the rear and a cleanout in the back. It would be loaded from the rear. The space between the body and barrel would be the combustion chamber. I'd use a propane charging system consisting of a metering pipe and a quick disconnect and a "Grill Ignitor Spark Plug" to initiate. (I'll post a separate Thread on that to keep this on topic.) Thoughts, ideas or input?


Top 
 Profile  
 
 Post Posted: Thu Nov 15, 2012 8:55 pm 
Offline

Joined: Thu Nov 15, 2012 8:13 pm
Posts: 11
This is a pretty wild idea. I dig it.

I'd suggest putting your spark towards the front of the gun to get the most out of your fuel. I'm figuring the flame has to travel down the chamber, turn, turn again, then push the projectile. If you ignite towards the loading end of the gun, you'll waste the fuel that's located at the front of the gun as it will ignite when the projectile is towards the end of the barrel.

How long were you thinking this would be?


Top 
 Profile  
 
 Post Posted: Sun Feb 03, 2013 8:39 pm 
Offline

Joined: Sun Feb 03, 2013 8:20 pm
Posts: 2
Location: usa
hi Swiat34 i just want to know if your AT4-styled launcher is already done i wanna see how it looks like and how it works? i'm planning to make one..


Top 
 Profile  
 
 Post Posted: Sun Jun 08, 2014 7:21 pm 
Offline

Joined: Thu Apr 05, 2012 8:20 am
Posts: 15
Hmm I like the Idea but I worry there might not be enough volume for air/gas. I tried this a few years ago with a 4" chamber and 1.5" barrel.
The barrel ran though a reducer coupling at each end of the 4" chamber and I drilled holes down the length of the 1.5" that was in the chamber.
It all came down to not enough air to mix with the propellent.
But I like what you have in mind I might try it out if you haven't already.
How are you going to support the barrel on the loading end? and you might want to give your self about 4-6" for combustion space instead of just 2

_________________
Spud gun list as of 2014
-Best: 4" PVC chbmr 2" barrel, breach load, combustion heptane/ether, longest range 362yd
-Largest: 6' PVC chbmr 3" barrel, breach load, combustion heptane/ether, longest range 128yd


Top 
 Profile  
 
Display posts from previous:  Sort by  
 
Post new topic Reply to topic  [ 4 posts ] 

Board index » General » Combustion Cannons


Who is online

Users browsing this forum: Bing [Bot] and 0 guests

 
 

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron